#include <SPI.h>
#include "epd2in13_V3.h"
#include "epdpaint.h"
#include "imagedata.h"

#define COLORED     0
#define UNCOLORED   1

/**
  * Due to RAM not enough in Arduino UNO, a frame buffer is not allowed.
  * In this case, a smaller image buffer is allocated and you have to 
  * update a partial display several times.
  * 1 byte = 8 pixels, therefore you have to set 8*N pixels at a time.
  */
unsigned char image[1050];
Paint paint(image, 0, 0);
Epd epd;

void setup()
{
  // put your setup code here, to run once:
  Serial.begin(115200);
  Serial.println("epd FULL");
  epd.Init(FULL);
  epd.Display(IMAGE_DATA);

  delay(2000);

  Paint paint(image, epd.bufwidth*8, epd.bufheight);    //width should be the multiple of 8

  paint.Clear(UNCOLORED);
  paint.DrawStringAt(8, 2, "e-Paper Demo", &Font12, COLORED);
  paint.DrawStringAt(8, 20, "Hello world", &Font12, COLORED);
  epd.Display1(image);//1

  paint.Clear(UNCOLORED);
  paint.DrawRectangle(2,2,50,50,COLORED);
  paint.DrawLine(2,2,50,50,COLORED);
  paint.DrawLine(2,50,50,2,COLORED);
  paint.DrawFilledRectangle(52,2,100,50,COLORED);
  paint.DrawLine(52,2,100,50,UNCOLORED);
  paint.DrawLine(100,2,52,50,UNCOLORED);
  epd.Display1(image);//2
  
  paint.Clear(UNCOLORED);
  paint.DrawCircle(25,25,20,COLORED);
  paint.DrawFilledCircle(75,25,20,COLORED);
  epd.Display1(image);//3
  
  paint.Clear(UNCOLORED);
  epd.Display1(image);//4

  delay(2000);

  // Serial.println("epd PART");
  // epd.DisplayPartBaseImage(IMAGE_DATA);
  // char i = 0;
  // for (i = 0; i < 10; i++) {
  //   Serial.println("e-Paper PART IMAGE_DATA");
  //   epd.Init(PART);
  //   epd.DisplayPart(IMAGE_DATA);
  //   Serial.println("e-Paper PART Clear");
	//   epd.Init(PART);
  //   epd.ClearPart();
  //   delay(2000);
  // }
  
  epd.Init(FULL);
  Serial.println("e-Paper clear and sleep");
  epd.Clear();
  epd.Sleep();

}

void loop()
{

}